Automatic
Transmission - Identification Procedures
NO: 21-20-95 Rev. A
GROUP: Transmission
DATE: Jan. 5, 1996
| SUBJECT: | RWD - Automatic Transmission Identification Procedures |
| MODELS: | 1992 - 1993 (AD) Ram Pickup/Cab Chassis 1992 - 1996 (AB) Ram Van/Wagon 1992 - 1996 (AN) Dakota 1994 - 1996 (BR) Ram Truck 1992 - 1996 (XJ) Cherokee 1992 - 1996 (YJ) Wrangler 1993 - 1996 (ZJ) Grand Cherokee |
DISCUSSION:
In an effort to reduce Automatic Transmission front pump whine, some internal changes were made in 1995 to the RWD Automatic Transmission. The following information is provided to help differentiate between all 1994/prior and 1995/1996 small and large box transmissions.
![]() |
The inlet port on the transmission case was enlarged by locally increasing the casting thickness. Figure 1
![]() |
Also on the case, the web between the inlet port chambers was removed. Figure 2
![]() |
Both the steel plate opening and the transfer plate in let port were enlarged to follow the case changes. Figure 3
![]() |
The front pump has an additional inlet port for the 95/96 model year. Figure 4
NOTE : These components are not interchangeable. Care should be used when ordering and installing replacement components. If the wrong parts are assembled together the transmission will induce air, even with the correct fluid level, into the valvebody and cause a sluggish, delayed engagement (similar to slipping). A harsh engagement following the initial launch in drive and reverse is also possible. To ensure that the correct components are installed, check the valvebody to case interface after installation and insure that the seam of the valvebody and case are identical.POLICY: Information Only